Timberline Machinery Inc.
7 Pittsburgh Ave                           Nashua, New Hampshire 03062, USA
Phone (603) 889-7233         Fax (603) 889-7300        Call Ed Makepeace

Close This Window

   Request Quotation or Additional Information

   Make an offer on this machine!


Sterling Davis-Standard blow molder with brand new Barber Coleman Maco 6500 controls !!!

Ref #

Manufacturer

Model

Year

Shot Capacity (pounds)

Head Configuration

Comments

30134 

Sterling Davis-Standard 

SE3505D 

1985 

dual 

brand new Maco 6500 microprocessor controls! 3.5 inch 100 HP extruder 


* 1985 Sterling Davis-Standard dual 5 pound accumulator head blow molder
* BRAND NEW BARBER COLEMAN MACO 6500 CONTROLS (installed at a cost of $45,000)
* Dual channel 100 point parison programming
* Very well maintained one-owner machine!

* 17 inch head centers
* 3.5 inch diameter, 24:1 L/D, 100HP extruder
* 550 pounds per hour plasticizing capacity
* 34 inch wide x 24 inch long clear platen
* 40 ton clamp
* Maximum open clamp daylight  44 inches
* Minimum clamp closed daylight  10 inches
* Three 3 inch diameter primary tie bars
* Forth removable tie bar for increased platen stability
  while still maintaining press accessibility for mold changes etc
* Base dimensions are 8 feet wide x 18 feet long x 8 feet high
* Installed machine height to top of head is 14 feet 2 inches
* Installed machine height to top of hopper is 14 feet 6 inches
* 40 HP main pump motor

OPTIONAL HEAD CONFIGURATIONS:
* Depending on our current in-stock inventory positions, 
  single 10 or 15 pound heads may be optionally available for this machine.

MICROPROCESSOR MACHINE CONTROL:
* Barber Coleman Maco 6500
* Touch-Trol operator station
     Remote and accessible with swing-away feature
     Set-up operation control buttons and switches
     Ammeter, tachometer, and speed control for DC drive
     Pressure indicator
* System/ Insta-set module
* Sequence module
* Five heat/cool module - six zones
* Temperature heat only modules - three 4-zones
* Linear positioning
* Multi-parameter process control speed for parison drop
* Pressure flow module
* Cabinet is provided with space for a maximum of 15 modules

MAIN ELECTRICAL CONTROL PANEL:
* Three door construction
* Motor starter for main hydraulic AC motor
* Ammeters on each heater zone for heater burn-out detection
* Mercury contactors with circuit breakers on heater zones
* Isolation transformer for microprocessor
* Main disconnect switch
* DC drive controls
* Panel climate control devise
* Voltage regulator

PRIMARY POWER WIRING:
- Maco 6500 is designed to operate from a 102-132 VAC, 50/60 Hz, single phase power source.  
Each module contains its own power supply which provides all operating voltages for the module 
circuitry.  Control equipment should not be connected to power sources subject to extreme voltage 
fluctuations caused by switching heavy loads. A voltage step-down isolation or voltage regulation 
transformer installed in the control cabinet is supplied.

-----------------------------------

NOTE: Although machinery descriptions are believed to be accurate and 
      are from sources deemed reliable, they are not guaranteed and we 
      invite your inspection prior to purchase.
We are one of the largest stocking dealers of plastics molding
machinery in the United States, and have been selling plastics
machinery worldwide for over 35 years. Our inventory is constantly
changing, and we are often liquidating complete plants. Please keep
in contact with us so that we can keep you informed of our latest
purchases.

Close This Window