INJECTION UNIT

Injection unit 			     FS-350 
Screw Diameter 			mm 	 64 	75 	84
Injection Capacity*1 		cm3/shot 772 	1060	 1329
Injection Rate 			cm3/sec  260 	357	 448
Injection Pressure 		kg/cm2 	 1507   1098     875
Plasticizing Capacity(PET) 	kg/H 	 208.9  331      460.5
Screw Stroke 			mm 	 	240
Screw Speed 		       rpm    H.T 0-159   L.T -2250

INJECTION STATION

Clamp Force, Upper 		kg 		49,500
Clamp Force, Lower 		kg 		51,000
Clamp Stroke, Upper 		mm 		340
Clamp Stroke, Lower 		mm 		270

HEATING STATION

Heating Core Stroke 		mm 		300
Heating Core Cylinder Dia 	mm 		 63
Heating Pot Stroke 		mm 		185
Heating Pot Cylinder Dia 	mm 		 63
Number of Heating Zone/Parison 			  3

STRETCH & BLOW MOLDING STATION

Stretch Stroke 			mm 		155
Stretch Cylinder Dia		mm 		100x2
Stretch Force 			kg 		1550
Blow Core Stroke 		mm 		300
Blow Core Cylinder Dia 		mm 		180
Blow Core Clamping Force 	kg 		2519
Blow Mold Clamping Force 	kg 		31,700
Blow Mold Clamping Stroke 	mm 		115
Bottom Mold Clamping Force 	kg 		6650
Bottom mold Clamping Stroke 	mm 		15
Blow Mold Platen Size(WxH) 	mm 		1100x315 

BOTTLE EJECT STATION

Ejector Stroke 			mm 		250
Ejector Cylinder Dia 		mm 		40

ELECTICAL SYSTEM

Electric Motor Unit 				1
Motor Size & Amperes 		KW/p/A 		75KW/4p/118A
Total Heating Capacity *2 	KW 		54.73
Control Circuit Voltage 	V 		100/110
Power Consuption,Rating 	KW 		129.7
		Working 	KW 		 90.8

HYDRAULIC SYSTEM

Amount of Hyd.Oil Required 	L 		1800
Pump Delivery (@7kg/cm2) 	L/min 		710
System Pressure, Max 		kg/cm 		140
Heat Ex. Water Required 	L/min 		160+40*3


Machine Operating Air,
	Pressure		kg/cm2 		9.9=140ps.
	Volume(@ Atmosphere)	L/min 		1560

Processing Air,
	Pressure 		kg/cm2 		14=199ps.
	Volume(@ Atmosphere)	L/min 		1800

Total Volume Required (PD) 	L/min 		3360


MOLD CHILLING REQUIREMENT (MIN. REQ'T)

Cooling Capacity 		Kcal/H 		44000
Operating Pressure, Min. 	kg/cm2 		3
Chilled Water Delivery 		L/min 		320